Industrial Installation Service

We provide maintenance and emergency service focused on reliability and minimising downtime. We carry out commissioning preparation, diagnostics, cleaning and drying, as well as emergency repairs — including on-stream work.

settings_suggest

Pipelines, Process Installations & Tanks

We prepare installations for operation and commissioning in accordance with procedures and process requirements. This covers drying, nitrogen purging, flushing, cleaning and leak diagnostics, with full documentation and waste management support.

check_circle Drying with compressed air and nitrogen (dew point down to –70°C)
check_circle Nitrogen purging of process installations (N₂)
check_circle Pipeline flushing (water, oil, process media) and chemical cleaning (pickling, passivation, BDO)
check_circle Cleaning/calibration: foam pigs, segmental pigs, jet cleaning
check_circle Video inspection of pipelines and process installations
check_circle Leak detection: Blow Door + Aerosol Photometer, Vacuum Box, gas detectors, thermography

On-Stream Repairs

We carry out repairs on live installations under pressure, without stopping the process. We use proven hot tapping and leak sealing technologies, selecting temporary or permanent solutions as required.

check_circle Hot Tapping (connections under pressure)
check_circle Bandage Wrap (reinforcing bands)
check_circle Leak Sealing Clamp Method (sealing clamps)
check_circle Encapsulation Repair Method (repair enclosure)
check_circle Leak sealing: flanges, valves, nozzles and welds
check_circle Emergency repairs: temporary and permanent solutions

Equipment Regeneration & Overhauls

We carry out regeneration and overhauls of equipment, focusing on restoring operating parameters and reliability. The scope includes diagnostics, replacement of consumable parts, adjustments and alignment of assemblies.

check_circle Overhauls and regeneration: pumps, valves, motors, heat exchangers
check_circle Compressor and refrigeration unit repairs
check_circle Technical condition diagnostics of equipment
check_circle Replacement: bearings, couplings, drive components
check_circle Adjustment, setting and alignment of mechanical assemblies

In-Situ Machining (On-Site)

We perform in-situ mechanical machining, enabling restoration of geometry and sealing surfaces without full disassembly of assemblies. This solution reduces downtime and logistics costs while maintaining the required precision.

check_circle Flange facing and sealing surface restoration
check_circle Valve seat repair and regeneration
check_circle Shaft and axle machining
check_circle Machining of structural components without disassembly
check_circle On-site turning and milling work